Controller Install

1. Install the controller
2. The controller will come with a set of keys and a spare fuse. Place the key in the door
   lock and the fuse in the battery compartment behind the faceplate. 
3. Place the weather station module in the module port and secure with the holding
   screw. 
4. If there are more than 4 zones, install an additional 4 station zone module.
5. Install the mounting plate, using four screws.
6. Install the air-card in a location that receives good service (usually as high as possible).
   This may need to be tested prior to final mounting on home. 
7. Install the weather station in a location that is not obstructed and is accessible to the
   weather.
8. Wire the zones to the controller.
9. Set a basic program for grow-in period (just in case remote access can not be achieved
   right away)
   1. Sprays – daily for 15-20 minutes
   2. Rotors – daily for 30-40 minutes
   3. Drip – based on emitter rate – daily for anywhere from 20 minutes to 30 minutes